Pelgrim IDK5104 Notice D'utilisation page 105

TROUBLESHOOTING
Symptom
A fuse blows as soon as the
hob is switched on.
The hob simply switches off.
The hob switches off during
use, is beeping approximately
for 10 seconds and the
display shows fault code
ER03.
Fault code ER22.
Fault code E2.
Fault code U400.
Fault code .
Fault code .
Other fault codes.
Possible cause
The hob has been wrongly
connected.
You accidentally touched the
On/Off button or touched two
buttons at the same time.
Something has boiled over
or there is an object on the
operating panel.
The control panel is filthy or
has water on it.
The hob has overheated.
The voltage is too high and/
or the hob is not properly
connected.
The childproof lock is
switched on.
You held a button too long.
Others.
Solution
Check the electrical
connections.
Switch the hob back on.
Clean the hob or remove the
object and then continue
cooking.
Clean control panel.
Let the hob cool down and
then use a lower setting.
Have your connection
changed.
See 'Child lock', page 13
and 14.
Do not hold the button too
long.
Contact the service
department.
GB 21