Building In - Pelgrim IDK5104 Notice D'utilisation

INSTALLATION

Building in

Check that the cabinet and the cut-out meet the dimension and
ventilation requirement
Threat the sawn ends of wooden or synthetic worktops with sealing
varnish if necessary, to prevent moisture causing the worktop to swell.
Lay the hob upside down on the worktop.
Fit the connecting cable to the appliance in compliance with
requirements (see page 24, 25 and 26).
Remove the protective layer from the sealing tape and apply the tape
in the groove of the aluminium profile or on the edge of the glass plate.
Do not stick tape round the corners, but cut 4 separate pieces to seal
the corners well.
Turn the hob over and lay it in the recess.
Fix the hob with the provided clamps. For worktops thinner than
35 mm, a filling block should be applied between the clamps and
the worktop. The screws should be fixed in the perforated holes.
Connect the appliance to the mains. A short bleep will be heard and all
the displays will light up briefly. The appliance is ready for use.
Check that it works properly. If the appliance has been wrongly
connected either a bleep will sound or nothing will appear in the
displays, depending on the error.
GB 27