General; Electrical Connection; Installation - Pelgrim ISWA990 Serie Notice D'utilisation

INSTALLATION

General

This appliance should be connected to the power supply by a recognized fitter who is familiar
with, and works according to the correct safety regulations. This appliance meets the European
requirements.
Important to know:
The minimum distance between the supporting surface for the cooking vessels on the
gashob and the lowest part of the range hood must be not less than 65 cm. For use with
an electric, ceramic or induction hob, this distance must be at least 50 cm.
If the cooker hood is to be fitted to an existing duct no other appliances, such as a
geyser or heater, may be connected to that same duct.
Consider local regulations with respect to the ventilation of gas appliances.
The shorter the duct, and the fewer the bends in it, the better the cooker hood will work.
Before you start drilling check that there are no installation cables present.
The connecting pipe for the cooker hood has a diameter of 120 or 150 mm. It is best also
to use a flue pipe of the same diameter.

Electrical connection

This appliance is manufactured in class I, it must therefore be
connected to the earth system.
Make sure the supply voltage ratings correspond with those stated on the appliance data plate.
The connection to the mains is carried out as follows:
BROWN = phase L
BLUE = phase N
YELLOW/GREEN = Earth
During the electrical connection make sure that the electrical socket is
equipped with earth connection.
This canopy hood has been provided with a power plug. When installing the hood, make sure
that this plug remains accessible.
EN 13