Expansion; Coding Switch; Registering - Alecto DBX-62 Mode D'emploi

6 EXPANSION

The DBX-62 is capable of registering up to 4 baby units. This way you
can monitor 4 babies and because you can assign an individual name to
each unit, you can directly determine which child is crying. Additionally,
for each baby unit you can set the talk-back function, feeding timer, room
temperature, lullabies and night light.

6.1 CODING SWITCH:

6.2 REGISTERING:

Upon expanding, you must register (re-register) ALL baby units,
also the baby units that were already registered.
Preparation:
Both the parent unit and baby unit must be switched off (parent unit:
briefly press and hold the
baby unit: slide the power switch to the OFF position), but the power
supply (adaptor or batteries) must be connected).
1. press and hold the TALK button on the rear of the parent unit
2. now press and hold the
the parent unit turns on and P/PAIRING appears in the display with
the P flashing. Now release both buttons
3. press and hold the + button on the baby unit
4. now slide the power switch to the ON position, the red light
turn on, and release the + button
5. briefly press the
'PAIRING BABY X (*) OK and you'll hear 2 beep tones from the baby
unit you just registered
6. repeat instructions 3, 4 and 5 for the other baby units
7. finally, turn the parent unit and all baby units off and back on
8. the registration is now complete
*: X = 1-4, corresponding to the position of the coding switch
In the battery compartment you'll find a coding switch with
4 positions corresponding with baby units 1, 2, 3 and 4.
Make sure to set an individual code for each baby unit.
button until the display is completely blank,
button, the display of the parent unit will show
button for approximately 3 seconds until
97
will