Using Multiple Baby Units - Alecto DBX-62 Mode D'emploi

6.3 USING MULTIPLE BABY UNITS:

• To make the use of multiple baby units easier, you can assign real
names to the baby units instead of 'baby-1', 'baby-2', etc. For this,
see paragraph 5.4.
• When all babies are sleeping and the baby units
are all set to sleep mode, the parent unit will
first show the status of baby unit 1 (temperature,
battery indication, night light or lullabies are
switched in, etc.), after 15 seconds the status of
baby unit 2, then unit 3 and finally unit 4. This
cycle is repeated for as long as all babies are
sleeping (or quiet).
- Unregistered baby units will be skipped.
- When a baby unit is registered, but not in communication with the
parent unit (out of range, empty battery, switched off), the parent
unit will emit a warning signal. Only after the cause for this out-of-
range notification is cleared, will the parent unit switch over to the
next baby unit.
• As soon as one of the babies starts crying, the parent unit will
instantly indicate the sound and status of the baby unit where the
crying is coming from. Don't forget that baby unit 1 always has the
priority; this means that when all babies are crying, the parent unit
will indicate the status of baby unit 1. The sequence is: baby-1,
baby-2, baby-3, baby-4.
- When several babies are crying, the status of
the first crying baby will be shown (see above
sequence) in the display, but the display will
indicate that another baby is crying.
Brian is crying, his status is indicated and
You can now briefly press the
the status and sounds of Angel (in the situation mentioned above).
you'll hear the sound
Angel is also crying
button to switch priority and check
98