System Expansion; Introduction; Add (Pair) A New Baby Unit; Deleting A Baby Unit - Alecto DVM-260+ Mode D'emploi

5

SYSTEM EXPANSION

5.1

INTRODUCTION:

The parent-unit can display a maximum of 4 cameras at once. The DVM-260 comes with one camera
(baby unit). Expansion Cameras can be ordered however through the website at: www.alecto.info
(Attention: in case you have a DVM-260+, then you should order a DVM-261+ extension camera)
5.2

ADD (PAIR) A NEW BABY UNIT:

Pair the baby unit with the parent unit using the following steps:
1. Make sure you have the new baby unit at hand, and that it is switched on.
2. Press the
3. Select with
4. Press the
5. Select the number of the camera which you want to allocate to the new camera by pressing the
or button (When the login screen shows a clear camera, then a camera has been paired to
this camera number, when the login screen show a light gray camera, then this number is still
free)
1
6. Press the
The parent-unit is now searching for the new camera
7. Press down the pairing button located at the bottom of the new baby unit until the power light
8.
pear in the window of the parent unit. The baby unit has now been successfully paired
will appear when the pairing has failed, repeat the pairing procedure if this occurs
9. Press the
5.3

DELETING A BABY UNIT:

You cannot delete an old baby unit, however once you pair a new baby unit in the position of an old
baby unit, it will invalidate the registration of the old baby unit.
70
button located on the parent unit
/ / / the option Camera
button
this camera number is already in use
button
button two times to exit the menu and to return to the image display.
will appear when pairing succeeded
2
This camera number is still free
will appear when pairing was
unsuccessful.
will ap-