Setting The Brewing Temperature; Service Mode 2 - Melitta Avanza Mode D'emploi

Changing basic settings
The following settings are possible:
Display
no coffee beans
Requirement: The appliance is ready for
operation.
Press the "Service" button for
1.
more than 2 seconds to call up Service
mode 1.
Press the "Service" button
2.
repeatedly until the display for the
Switch-off rinsing function appears.
Press the "Coffee strength" button
3.
repeatedly until switch-off rinsing is
activated or deactivated.
You can call up the next function
4.
or exit Service mode:
a) Briefly press the "Service" button to
navigate to the next function.
b) Press the "Service" button for more
than 2 seconds to save the setting
and exit the service mode.
6.5 Setting the brewing
temperature
The brewing temperature influences the
flavour of the coffee beverage.
The following settings are possible:
Display Brewing temperature
Low
Medium
High
Requirement: The appliance is ready for
operation.
Press the "Service" button for
1.
more than 2 seconds to call up Service
mode 1.
46
Switch-off rinsing
activated
deactivated
Press the "Service" button
2.
repeatedly until the display for the
Brewing temperature function appears.
Press the "Coffee strength" button
3.
repeatedly until the desired brewing
temperature is set.
You can call up the next function
4.
or exit Service mode:
a) Briefly press the "Service" button to
navigate to the next function.
b) Press the "Service" button for more
than 2 seconds to save the setting
and exit the service mode.

6.6 Service mode 2

Each function is assigned a display.
Service mode 2
Display function
Factory settings
Venting
To call up Service mode 2, proceed as
follows:
Requirement: The appliance is ready for
operation.
Press the "Service" button as
1.
well as the "Coffee" direct key for more
than 2 seconds to enter Service
mode 2.
The Ready display and the 2
»
cups display flash rapidly.
Press the "Service" button one or
2.
more times to access the desired
function.
» A display lights up according to the
function selected, see Service mode 2
table.
» The number of lit bean symbols
indicates the current setting of the
function.