Setting Instructions - ProMinent DHV-S-DL Mode D'emploi

ProMinent ®
CAUTION
• System components may burst if the setting pressure is
adjusted too high!
The setting pressure P
always be lower than the maximum permissible operating
pressure P of pulsation dampers, pumps and line systems.
N
• Please note that hazardous situations can arise when the
backpressure valve has not yet been set in the system and
the shut-off elements are opened or the system is started
up! Take the necessary precautions!
NOTE
The setting pressure P at the backpressure valve must always be
E
greater than the admission pressure P
pressure ∆P resulting from mass deceleration (∆P is approx. 1.5 bar
in standard lines up to approx. 3 m).
The admission pressure P1 as the result of the height h is

Setting instructions

CAUTION
• The backpressure valve must be set under the same
operating conditions as it will be subsequently used!
Never set the valve on a test rig and then install it in a
system! (Also observe the viscosity of the metered medium!)
NOTE
Pressure adjusting screw
... turn in
... turn out
Pressure relief knob
Upper stop
Lower stop + 1 turn
Commissioning
at the backpressure valve must
E
plus the differential
1
= h x ρ
P P in bar
1 1
h in m
ρ in kg/cm
Backpressure
Higher
Lower
Backpressure
High
Low
3
21