ETNA T311FZT Mode D'emploi page 106

ERRORS
Symptom
The hob switches off during
use, 4 dashes are displayed.
A row of dashes or F0 is
displayed.
Error code F0
After switching on a cooking
zone, the operating panel
display continues to flicker.
Error code F5 or F6
The pans make a noise while
cooking. Your hob makes
ticking noises during cooking.
The ventilator continues to work
for several minutes after the hob
has been switched off.
Ceramic glass plate broken.
EN 22
Possible cause
Something has boiled over
or there is an object on the
operating panel.
The electronic circuits are
warm.
Pan has boiled dry or is too hot. Allow the appliance to cool
The pan you are using is not
suitable for induction cooking
or has a diameter of less than
12 cm (10 cm for the 16 cm
cooking zone).
Appliance overheated due to
insufficient ventilation.
Normal for certain types of pan.
This is caused by energy being
transmitted from the hob to
the pan.
The electronics are cooling
down. Normal operation.
Object fallen onto it.
Solution
Clean the hob or remove
the object and then
continue cooking.
See chapter on installation.
down or continue cooking
on a lower setting.
See chapter on pans for
induction cooking.
Check how the hob is built-
in or contact the Service
Department.
Nothing. There is no
danger to the hob or to
your pan.
Nothing.
Switch and pull the plug
out of the socket. Contact
your technician.
Please note! You should
not throw a broken
ceramic glass plate in
the glass recycling bin
but should take it to the
Municipality's waste
recycling centre.