Commissioning (Carriage) - Roco 41273 Manuel D'utilisation

Place the 3 carriages on the track without the locomotive!
1. Creating the carriage (same as creating a new locomotive):
GB
 Press ESC
 "NEW LOC" --> press OK
"Database" --> press OK --> rotate to Loc 37540 --> press OK `BR55´
You have now successfully created the car-riage but this is still at another address. Change the address as
follows:
2. Setting the address (at another address as the locomotive so that all functions can be use):
 Press ESC
 Rotate to the right "CHANGE LOC" --> press OK
 "Address" --> press OK
 Rotate. e.g. to address "5/6 --> press OK
 "PRG LOC?" --> press OK
The carriage has now been successfully programmed at the new address (a beep sounds 3 times)
3. Setting the function keys:
 Press ESC
 Rotate to the right "CHANGE LOC" --> press OK
 Rotate 2x to the left to "REG" --> press OK
 Rotate until REG "61" flashes" --> press OK
 Rotate until REG 61: "3" flashes" --> press OK (lamps flash)
The carriages have now been programmed with the corresponding function key occu-pancy (a beep
sounds 3 times).
4. Changing the name:
 Press ESC
 Rotate to the right "CHANGE LOC" --> press OK
 Rotate to the right "NAME" --> press OK
 Change letters with rotary controller
 Continue by pressing the rotary knob
 Return by pressing ESC
 Finish with OK
37
Digital Waggon.indd 37 22.10.2008 09:53:14