Operation With The Märklin Mobile Station; Commissioning (Locomotive) - Roco 41273 Manuel D'utilisation

Operation with Märklin Mobile Station
1)
Commissioning:
Place the locomotive on the track without the carriage!
1. Creating the locomotive:
GB
 Press "ESC"
 „NEW LOC" --> press OK
 "Database" --> press OK --> rotate to Loc 37540 --> press OK 'BR55'
You have now successfully created the loco-motive but this is still at another address. Change the address
as follows:
2. Setting the address:
 Press "ESC"
 Rotate to the right "CHANGE LOC" --> press OK
 "Address" --> press OK
 Rotate. e.g. to address "3/4" --> press OK
 "PRG LOC?" --> press OK (lamps flash)
You have now successfully set the address and can use the locomotive.
Do the following in order to address the functions as shown in the table on the next page:
3. Setting the function keys:
 press "ESC"
 rotate to the right "CHANGE LOC" --> press OK
 rotate 2x to the left "REG" --> press OK
 rotate until REG "65" flashes --> press OK
 rotate until REG 65: "3" flashes --> press OK (lamps flash)
The locomotive has now been programmed with the corresponding function key occu-pancy.
You can now switch the functions in accor-dance with the table.
Change the names as follows:
4. Changing the name:
 Press "ESC"
 Rotate to the right "CHANGE LOC" --> press OK
 Rotate to the right "NAME" --> press OK
 Change letters with rotary controller
 Continue by pressing the rotary knob
 Return by pressing "ESC"
 Finish with OK
36
Digital Waggon.indd 36 22.10.2008 09:53:14