Carriage Settings; Address; Configuration (Cv29); Carriage Settings (Cv62) - Roco 41273 Manuel D'utilisation

If you wish to programme other decoders (e.g. in the locomotive, carriage, etc.), you must remove
the carriage with the revolving door from the track as this will otherwise also be programmed.

Address

The carriage is programmed at address 3 in the delivery state.
The carriage can be programmed at diverse addresses between 1-99 via CV1. 9999 addresses are possible
via the long addressing (CV17/18) (this requires the activation of an additional CV29 Bit5, see CV list).
The tail lamp of the carriage is logically coupled to the locomotive (direction of travel,
activation) if the addresses are the same.
Configuration (CV29)
Decoder configurations are possible via CV29. In the CV list, each of the configura-tions has a value. The
required settings (values) are to be added and CV29 programmed with them.
Bit 0 (value 1 or 0) changes the direction if the carriage is coupled to the locomotive the wrong way round.
The tail lamp is now conform with the direction.
Bit 1 (value 2 or 0) comprises the number of running steps. This is important for a correct, direction-related
illumination of the tail lamp and must be conform with the running step setting/operation ion the
multi MAUS/controller. A flashing of the tail lamp when rotating the running controller is an indication
of an incor-rect running step setting.
Bit 2 (value 4 or 0) switches the analogue operation on or off.
Bit 5 (value 32 or 0) switches the „long address" mode on or off.
Die Kombinationen der Einstellungsmöglichkeiten befinden sich im Kapitel "CV-Combinations".

Carriage settings (CV62)

You can make additional carriage settings with regard to the conductor and the door movement via CV62.
In the works setting, the 2
nouncement and whistle come from this carriage.
Carriage configuration via CV62 (conductor's carriage)
CV62 Carriage
1 class
st
1 /2 class
st nd
2 class with tail lamp
nd
If you wish to define the 1
program value "3" at CV62.
Resetting to the work setting
The CV settings of the carriage are reset to the works setting by value 8 being programmed at CV8.
The door mechanic of the carriage goes to the starting state when you program value 7 at CV7.
Digital Waggon.indd 29

Carriage settings

class carriage is defined as the conductor's carriage, i.e. the conductor an-
nd
Type
no whistle and announcement
no whistle and announcement
with whistle and announcement
class as being the conductor's carriage (i.e. with whistle and announcement),
st
GB
Works value
0
0
3
29
22.10.2008 09:53:12