Locomotive Settings; General Information; Instructions On The Linking Of Running With Sound; Cv List For The Locomotive - Roco 41273 Manuel D'utilisation

General information

The LokSound (LokSound) decoder has been optimally adjusted to this loco-motive. You can still adapt nu-
merous decoder properties to your wishes however. Certain parameters (referred to as CVs – Configuration
Variable – or register) can be amended.
Please check before each programming if this is really necessary. Incorrect settings can result in the decoder
not reacting correctly.
The decoder is preprogrammed with 28 driving stages at the factory for a high level of comfort. This means
that it can be used together with all of the modern DCC ( multi MAUS) and Motorola
The LokSound decoder has been especially modified for the additional functions and is not to be
replaced with a decoder which is available from a retailer.
 This can result in the pantograph drives suffering a defect!
If the locomotive is to be reprogrammed, only the locomotive is to be on the programming track.
It is imperative that the rest of the train is decoupled as the programming will otherwise not be
executed or the carriage will also be programmed.

Instructions on the linking of running with sound

This sound decoder of the latest generation enables a stronger linking of running and sound processes. For
example, when the sound is activated (Function key «F1» activated) only starts to move after the «engine»
sound sequence has been fully completed and «engine idling» has been reached, just as with the original.
Vice versa, the «engine off» sound sequence only runs after the Function key F1 (now «sound off») has been
activated again, followed by the «engine idling» status, if the locomotive is already at a standstill when the
key «F1» has been activated. This means that a fast switching of the sound on or off using the key «F1» is
only possible if the locomotive is already or still moving.
CV- list for the locomotive
CV Name
1 Adress (= short address)
2 Start-up voltage
(lowest creeping speed)
3 Acceleration duration
(from standstill to maximum speed)
4 Braking duration
(from maximum speed to stand-still)
5 Maximum speed
6 Medium speed
(at medium running step)
8 Resetting of all values to the works
settings; (With readable amplifiers/controllers,
the manufacturer ID is readable)
Digital Waggon.indd 27

Locomotive Settings

Adjustable Values
control devices.
2)
Default
Values
00 – 99
00 – 75
00 – 64
00 – 64
00 – 64
00 – 64
08=Reset
---------------------
GB
03
03
14
07
38
22
27
22.10.2008 09:53:11