Installation; Installing The Safety Assembly; Appliance Installation; Water Connection - Stiebel Eltron SHU 5 SLi comfort Utilisation Et Installation

INSTALLATION

Installation
9. Installation
Material losses
!
When using plastic pipework, observe the extreme op-
erating and fault conditions that can occur on the appli-
ance (see chapter "Installation / Specification / Extreme
operating and fault conditions").
f To provide a supply to two washbasins, use the "water dis-
tribution tees" (see chapter "Installation / Appliance descrip-
tion / Required accessories").
f Run the connections to the second tap on site, e.g. in 10 mm
copper pipe.
9.1

Installing the safety assembly

f Fit the safety assembly in the cold water supply line of the
appliance.
f Observe the information on the safety assembly (see chapter
"Installation / Safety / Information on the safety assembly").
f Observe the information in the safety assembly installation
instructions.
9.2

Appliance installation

f Mark out the drill holes using the installation template (see
middle part of these instructions).
f Drill the holes and insert suitable rawl plugs.
f Secure the wall mounting bracket using suitable screws.
f Hang the appliance on the wall mounting bracket.
Note
Surplus cable can be stored in the cable compartment.
www.stiebel-eltron.com
100-200
°C
82 35
65 Eco 55
9.3

Water connection

Material losses
!
Carry out all water connection and installation work in
accordance with regulations.
Material losses
!
When tightening the fittings, counterhold with a suitable
spanner.
Material losses
!
The appliance may lose its function.
f Never interchange the water connections.
f Set the flow rate (see safety assembly instructions).
Observe the maximum permissible flow rate with a
fully opened tap (see chapter "Installation / Specifi-
cation / Data table").
f Connect the hydraulic connections with flat gaskets.
Match up the colour coding on the water connections of the tap
and the appliance:
- R.h. side blue = "Cold water inlet"
- L.h. side red = "DHW outlet"
f Secure the tap connections to the appliance.
Note
Ensure that the water connections are not kinked during
installation. Prevent any tensioning during installation.
9.4

Power supply

WARNING ELECTROCUTION
Carry out all electrical connection and installation work
in accordance with relevant regulations.
WARNING ELECTROCUTION
In the case of permanent connection to the power sup-
ply via a junction box, ensure that the appliance can be
isolated from the mains by an isolator that disconnects
all poles with at least 3 mm contact separation.
WARNING ELECTROCUTION
Ensure that the appliance is earthed.
14
19
SHU 5 | 15