Modify Acknowledgment Settings - Lutron Radio Touch RTA-RS232 Guide D'installation Et De Mise En Service

Advanced Programming (continued)

Modify Acknowledgment Settings

The Acknowledgment setting should remain OFF
unless you have a special requirement to control
multiple rooms from a master host device. In this
mode an ACK will be returned when a command has
been completely sent via RF from the desired
interface. If you need to use this feature, contact
Lutron Technical Support at 1-800-523-9466 for
more details, then continue with this section.
Press and hold the CONF and ADDR buttons for 5
seconds to enter unit configuration mode. The LED
display will begin flashing UC to alert you that the
unit has entered unit configuration mode.
Press the CONF button repeatedly until the display
shows AC. Press the OK button to display the
current setting on the right LED display.
Press the right scroll button to select between I
(Acknowledge mode ON) and 0 (Acknowledge mode
OFF).
Press OK to confirm the setting you require. The 3
LEDs around the display will flash to signal the
change has been made.
Note: Pressing the left scroll button will display the
current configuration for this mode.
Press and hold the CONF and ADDR buttons for 5
seconds to exit unit configuration mode. The display
will start to sequence (approximately 5 seconds).
22 RadioTouch RTA-RS232 Programming and Operation Guide
TM
TX RX
Press and hold for 5 seconds to enter or exit unit
configuration mode.
TX RX
Press CONF until the LED
display reads AC.
TX RX
Press the right scroll
button to select the mode.
Then press OK.
Then press OK.
R