Adds The Rta-Rs232 To An Rf Controller; Delete Deletes The Rta-Rs232 From An Rf Controller; Allows The Host To Query The Configuration Settings Of The Rta-Rs232 - Lutron Radio Touch RTA-RS232 Guide D'installation Et De Mise En Service

Command Set: Configuration Commands
Command Name
Description
Syntax
Allowed Values
Example
Additional Information
Command Name
Description
Syntax
Allowed Values
Examples
Additional Information
18 RadioTouch RTA-RS232 Programming and Operation Guide
TM
ADD/DELETE (add or delete the interface from a controller)
Adds or deletes the RTA-RS232 to a RadioTouch controller.
:CON,[function],[zone number]<CR>
Function: ADD or DELETE
Zone number: 0 through 9
:CON,ADD,5<CR> Adds zone 5 of the RTA-RS232 to the controller
To add or delete the RTA-RS232, each controller must be in program mode. See
the RadioTouch Installer's Guide for more details.
RPT (report configuration settings)
Allows the host to query configuration settings for the RTA-RS232 interface.
:CON,RPT,[category],[parameter]<CR>
Category: TYPE Zone type
HAND Data flow control configuration
RB Reply back mode
ACK Acknowledgement mode
REV Software revision
Parameter: 0 - 9 Desired zone (applies only to TYPE)
M Master microprocessor (applies only to REV)
S Satellite microprocessor (applies only to REV)
:CON,RPT,TYPE,2<CR>
:CON,RPT,RB<CR>
Parameter can be omitted if not applicable. See page 19 for RTA-RS232 responses
to configuration queries.
Requests zone configuration for zone 2
Requests the status of reply back mode
R