Modify Reply Back Settings - Lutron Radio Touch RTA-RS232 Guide D'installation Et De Mise En Service

Advanced Programming (continued)

Modify Reply Back Settings

The default mode is for the RS232 interface to send
OK and error messages back to the host device. If
your device is unable to process this information,
continue with this section to turn Reply Back
messages OFF.
Press and hold the CONF and ADDR buttons for 5
seconds to enter unit configuration mode. The LED
display will begin flashing UC to alert you that the
unit has entered unit configuration mode.
Press the CONF button repeatedly until the display
shows rb. Press the OK button to display the current
setting on the right LED display.
Press the right scroll button to select between I
(Reply Back mode ON) and 0 (Reply Back mode
OFF).
Press OK to confirm the setting you require. The 3
LEDs around the display will flash to signal the
change has been made.
Note: Pressing the left scroll button will display the
current configuration for this mode.
Press and hold the CONF and ADDR buttons for 5
seconds to exit unit configuration mode. The display
will start to sequence (approximately 5 seconds).
R
TX
Press and hold for 5 seconds to enter or exit unit
configuration mode.
TX
Press CONF until the LED
display reads rb.
TX
Press the right scroll
button to select the mode.
RadioTouch RTA-RS232 Programming and Operation Guide
TM
RX
RX
Then press OK.
RX
Then press OK.
21