Tells The Rta-Rs232 To Enter Configuration Mode; Tells The Rta-Rs232 To Exit Configuration Mode; Sets The Zone Type To Lights, Contact Closures, Or Unassigned; Tells The Rta-Rs232 To Turn Reply Back Mode On Or Off - Lutron Radio Touch RTA-RS232 Guide D'installation Et De Mise En Service

Command Set: Configuration Commands
The following commands will configure the RTA-RS232 product. Each is prefixed with the CON command.
When setting the RTA-RS232 configurations, the host must first enter configuration mode on the RTA-
RS232. After completing the configurations, the host must then exit configuration mode on the RTA-
RS232. If the system is in configuration mode, the only commands that the RTA-RS232 will execute are
configuration commands. All other commands will be ignored. Conversely, if the RTA-RS232 is not in
configuration mode, it will ignore all configuration commands.
Command Name
Description
Syntax
Allowed Values
Example
Additional Information
Command Name
Description
Syntax
Allowed Values
Example
Additional Information
Command Name
Description
Syntax
Allowed Values
Example
Additional Information
Command Name
Description
Syntax
Allowed Values
Example
Additional Information
R
ENTER/EXIT (enter or exit configuration mode)
Tells the RTA-RS232 to enter or exit configuration mode.
:CON,[command]<CR>
Command: ENTER or EXIT
:CON,ENTER<CR>

Tells the RTA-RS232 to enter configuration mode

The ENTER command must be executed to set RTA-RS232 configurations; the
EXIT command must be executed after the configuration is complete. When the
system is in configuration mode, the only commands the RTA-RS232 will execute
are configuration commands.
TYPE (set zone type)
Sets the zone type to lights (L), contact closures (C), or unassigned (-).
:CON,TYPE,[zone number],[type]<CR>
Zone number: 0 through 9
Type: L (lighting zone), C (contact closure zone), or - (unassigned)
:CON,TYPE,5,L<CR> Sets zone 5 as a lighting zone
Type S is an unused zone type; do not use.
RB (reply back mode)
Turns reply back mode on or off.
:CON,RB,[status]<CR>
Status: ON or OFF
:CON,RB,ON<CR> Turns reply back mode on
The default state of reply back mode is on.
ACK (acknowledgment mode)

Turns acknowledgment mode on or off.

:CON,ACK, [status]<CR>
Status: ON or OFF
:CON,ACK,ON<CR> Turns acknowledgment mode on
The default state of acknowledgment mode is off.
RadioTouch RTA-RS232 Programming and Operation Guide
TM
17