Configure Zone Types - Lutron Radio Touch RTA-RS232 Guide D'installation Et De Mise En Service

Programming

Configure Zone Types

A.Press and hold the CONF and ADDR buttons for 5
seconds to enter unit configuration mode. The LED
display will begin flashing UC to alert you that the
unit has entered unit configuration mode.
B.Press the CONF button repeatedly until the display
shows CC. Press the OK button to begin configuring
zone types.
To configure a zone, use the table you filled in on the
previous page.
C.Use the left scroll button to select the zone number
you wish to program. Use the right scroll button to
select the correct zone type (L, -, or C).
D.Once the correct zone number and type are
displayed, press OK to confirm the setting. The three
LEDs will flash to alert you that the change has been
made.
Repeat these steps until all your zones have been
configured.
Press and hold the CONF and ADDR buttons for 5
seconds to exit unit configuration mode.
6 RadioTouch RTA-RS232 Programming and Operation Guide
TM
A
TX RX
Press and hold for 5 seconds to enter or exit unit
configuration mode.
B
TX RX
Press CONF until the
display shows CC.
C
TX RX
Use the left scroll
button to change the
zone number.
D
TX RX
Press OK to confirm this zone
setting, then use the scroll
buttons to set the next zone.
Then press OK.
Use the right scroll
button to change the
zone type.
R