Command Summary; Configuration Commands - Lutron Radio Touch RTA-RS232 Guide D'installation Et De Mise En Service

Command Set (continued)

Command Summary

RTA-RS232 Commands
Command Description
PS Sets the indicated zone to a predetermined preset level
XC Sets the intended zone to an explicit level between the minimum and maximum levels
BSTP Tells the RTA-RS232 to raise or lower the level for the indicated zone
ESTP Tells the RTA-RS232 to stop raising or lowering the zone level
PSA Tells the indicated zone to enter/exit Preset Adjust mode
SPS Programs the indicated preset level to the current light level
PHC Tells the indicated zone to enter/exit daylight sensor calibration mode
PING Forces a prompt from the RTA-RS232 (used on power-up to start data flow)

Configuration Commands

Command Description
ENTER Tells the RTA-RS232 to enter Configuration mode
EXIT Tells the RTA-RS232 to exit Configuration mode
TYPE Sets the zone type to Lights, Contact Closures, or Unassigned
RB Tells the RTA-RS232 to turn Reply Back mode on or off
ACK Turns Acknowledgment mode on or off
ADD Adds the RTA-RS232 to an RF controller
DELETE Deletes the RTA-RS232 from an RF controller
RPT Allows the host to query the configuration settings of the RTA-RS232
RTA-RS232 Responses
Command Description
! (PROMPT) Tells the Host there is room in the RTA-RS232 buffer for another command
CON Informs the host of the current configuration settings
ERROR Provides error codes when an error is detected (Reply Back mode must be on)
OK Responds OK when a command is successfully processed (Reply Back mode must be on) 19
ACK Issued by the RTA-RS232 when it complete RF transmission of the current command
(if Acknowledgment mode is turned on)
R
RadioTouch RTA-RS232 Programming and Operation Guide
TM
Page
14
15
15
15
15
16
16
16
Page
17
17
17
17
17
18
18
18
Page
19
19
19
19
13