Yamaha FX Nytro 2008 Manuel D'atelier page 532

CRANKSHAFT AND BALANCER SHAFT
2
1
a
a
a
2
1
4. Tighten:
• Balancer weight bolts 1
NOTE:
Place a wood a between the balancer weight 2
and crankcase.
5. Bend the lock washer tab.
1
2
6. Install:
• Crankshaft journal upper bearings
• Crankshaft journal lower bearings
NOTE:
• Align the projections a on the crankshaft journal
bearings with the notches b in the crankcase.
• Be sure to install each crankshaft journal bearing
in its original place.
7. Install:
• Bearing 1
NOTE:
Be sure to install the bearing so that its hole a is
near the bearing edge that is facing away from the
primary sheave drive shaft assembly.
5-75
ENG
Balancer weight bolt:
35 Nm (3.5 m · kg, 25 ft · lb)
(into the upper crankcase)
(into the lower crankcase)
(to the primary sheave drive shaft assembly
2)