Yamaha FX Nytro 2008 Manuel D'atelier page 220

a
b
2 1
3
1
4
1
3
4. Install:
• Steering shaft 1
• Locknuts 2
• Joints 3
È Steering shaft
part number
8GL-23820-00
2 3
CAUTION:
Always use new cotter pin.
5. Bend the lock washer tab along a flat side of the
bolt.
6. Adjust:
• Skis
Adjustment steps:
• Temporarily install the handlebar.
• Hold the handlebar straight and check that the
2
skis are at right angles to the handlebar.
• Install the steering linkage alignment plate 1.
NOTE:
To install the steering linkage alignment plate, turn
the handlebar completely to the right, position the
plate behind the steering column 2, and then fit the
steering column into the cutout in the plate and fit
the nut 3 into the hole in the plate. Then, while
turning the handlebar to face it straight ahead, fit
the bolt 4 into the hole in the plate.
3-13
CHAS
STEERING
É Set length
a
232.2 mm
(9.14 in)
Steering shaft and pivot arm nut:
35 Nm (3.5 m · kg, 25 ft · lb)
Steering shaft and steering column
nut:
35 Nm (3.5 m · kg, 25 ft · lb)
Steering linkage alignment plate:
90890-01531, YS-01531
Ê Shaft
length b
174.2 mm
(6.86 in)