Brouwland Lactoferm Soyferm Mode D'emploi page 25

Cause
Screen-inner slips out of joint
The screen-inner is not screwed tight enough
The beans are not grinded
The voltage is too low
Too much or not enough beans
Not enough water
The wholes of the screen-inner are jammed
Overflow
Too much water in the machine
The anti-overflow tube is filthy
The beans are filthy
"Out of order"-alarm
Not enough water
The temperature of the added water is too low
Scorch
Too much or not enough beans
The consistence of the milk is not good
The whole of the screen-inner is jammed
The soaking time of the beans is not correct
Warranty
The Soyferm soy drink maker has been manufactured with the greatest care and comes with a two
year warranty. Always keep proof of your purchase. Damage as a result of unauthorised use is not
covered. This appliance is suited for 220 volt, 50 Hz.
Problem analysis
Solution
Screw tight along the arrow head
Steady the voltage
Add the correct quantity of beans
The added water has to reach the lower
level line. Add the correct quantity of
water
Clean the inner-screen with a toothbrush
Add the correct quantity of water
Clean the anti-overflow tube
Wash the beans
The added water has to reach the lower
level line. Add the correct quantity of
water
Use water between 10 and 40°C
Add the correct quantity of beans and
water.
Clean the whole of the screen-inner with
a toothbrush
Soak the beans as explained in the reci-
pes.
E
25