Publicité
D. Liberally lubricate both beads. Place the wheel WITH
DROP CENTER UP (Fig. 4.1-3a) on the turntable, and
clamp in position. It may be necessary to hold the tire and
wheel down while clamping to insure contact between rim
and clamp as shown in 4.1-3a.
Fig. 4.1-3
WARNING: MOVE YOUR HANDS AWAY FROM
THE RIM BEFORE OPERATING THE TOOL DOWN-
STROKE.
E. Gently position the mount/demount head in contact with
the rim edge and lock it into place: the tool automatically
moves away from the rim edge vertically and horizontally,
approximately 1/25" (1 mm): this is necessary to avoid
any rim contact during the changing process. (Fig. 4.1-4).
Fig. 4.1-4
Fig. 4.1-3a
EEWH311C
Keep hands and fi ngers clear of mount/
demount head during operation.
4.1.1
ANGULAR TOOL ADJUSTMENT
The tool is adjusted at the factory with an optimal angle
for most wheels used today. However, the angle can be
optimised for wheels with a diameter that differs conside-
rably from the standard.
To adjust the tool angle, proceed as follows:
1. Mount the rim for which the adjustment is required.
2. Loosen the lower screw (1, Fig. 4.1-5).
3. Adjust the tool with the screws shown (2a and 2b,
Fig. 4.1-5). Unscrew the screw (2a or 2b, Fig. 4.1-5)
to rotate the tool, respectively clockwise or counter-
clockwise.
4. Screw in the opposite screw to block the tool in the
desired angular position.
5. Tighten the lower screw (1, Fig. 4.1-5) with a torque of
35 Nm.
2a
332a
Fig. 4.1-5
DANGER!!
2b
1
18
Publicité
