Publicité
OPErATiON
General information
OPErATiON
1.
General information
The chapters "Special Information" and "Operation" are intended
for both the user and qualified contractors.
The chapter "Installation" is intended for qualified contractors.
Note
Read these instructions carefully before using the appli-
ance and retain them for future reference.
Pass on the instructions to any new user where appro-
priate.
1.1
Safety instructions
1.1.1 Structure of safety instructions
KEYWORD Type of risk
!
Here, possible consequences are listed that may result
from failure to observe the safety instructions.
f Steps to prevent the risk are listed.
f
1.1.2 Symbols, type of risk
Symbol
Type of risk
Injury
!
Electrocution
Burns
(burns, scalding)
1.1.3 Keywords
KEYWOrD
meaning
DANGER
Failure to observe this information will result in serious
injury or death.
WARNING
Failure to observe this information may result in serious
injury or death.
CAUTION
Failure to observe this information may result in non-seri-
ous or minor injury.
1.2
Other symbols in this documentation
Note
General information is identified by the adjacent symbol.
f Read these texts carefully.
f
4
| SHP-A 220-300 Plus
Symbol
meaning
Material losses
!
(appliance damage, consequential losses and environmen-
tal pollution)
Appliance disposal
f This symbol indicates that you have to do something. The ac-
f
tion you need to take is described step by step.
…
…
These symbols show you the software menu level (in
this example level 3).
1.3
Units of measurement
Note
All measurements are given in mm unless stated oth-
erwise.
1.4
Standardised output data
Explanations to determine and interpret the specified standardised
output data
Standard: EN 16147
The output data specifically mentioned in text, diagrams and
technical datasheets has been calculated according to the test
conditions of the standard shown in the heading of this section.
Generally, these standardised test conditions will not fully meet
the conditions found at the installation site of the system user.
Depending on the chosen test method and the extent to which this
method deviates from the conditions defined in the norm shown in
the heading of this section, any deviations can have a considerable
impact. Further factors that have an influence on the test values
are the measuring equipment, the system configuration, the age
of the system and the flow rates.
A confirmation of the specified output data can only be obtained
if the conditions applicable to the relevant test match those of the
standard shown in the heading of this chapter.
2.
Safety
2.1
Intended use
The purpose of this appliance is to heat domestic hot water within
the application limits stated in the chapter "Specification / data
table".
This appliance is intended for domestic use. It can be used safely
by untrained persons. The appliance can also be used in a non-do-
mestic environment, e.g. in a small business, as long as it is used
in the same way.
Any other use beyond that described shall be deemed inappropri-
ate. Observation of these instructions and of instructions for any
accessories used is also part of the correct use of this appliance.
www.stiebel-eltron.com
Publicité
