Güde GD 20 I Mode D'emploi Original page 11

3. Fit the heating unit on the wheel support frame. Make
sure the heating unit air inlet (rear) is above the
wheels. Attach the fuel tank flange holes to the wheel
support frame holes.
4. Put the front and rear handle on the fuel tank flange.
Pull the screws through the handles, fuel tank flange
and wheel support frame. After the screw is inserted,
tighten the appropriate nut with your hand.
5. Tighten the nuts after all screws have been inserted.
Safety equipment
The oil hot-air turbine is fitted with an electronic flame
control. The appliance is stopped in case of operating
failure. If the oil hot-air turbine is overheated, thermostat
preventing overheating is activated, which interrupts the
fuel supply; the thermostat is automatically deactivated if
the combustion chamber temperature drops below the
accepted maximum value. The overheating cause must be
identified and removed (e.g. air inlet and outlet blocking or
fan stopping) before putting the oil hot-air turbine back into
operation. To start the appliance again, please follow the
instructions included under "PUTTING THE APPLIANCE
INTO OPERATION".
Putting the appliance into operation
Before putting the oil hot-air turbine into operation and
plugging it in, it is necessary to check whether the power
supply properties correspond to the values on the type
label.
CAUTION:
A safety switch against stray current (RCD) must be
integrated in the circuit to which the oil hot-air turbine
is connected.
All safety measures regarding ventilation, etc. must be
adhered to.
Do not add crude oil to the fuel tank. Close the fuel
tank lid again.
Plug the heating unit feeder cable in a standard socket
with earth contact.
The following must be provided to put the appliance
into operation:
Turn the ON/OFF switch to the ON position: the fan will
start and cause ignition after a couple of seconds.
Ignition may take a few seconds when the appliance is
started for the first time or after it has not been used for a
long time.
The following must be provided to switch the
appliance off:
Turn the ON/OFF switch to the OFF position.
Marking
Product safety:
Product corresponds to
appropriate EU standards
Prohibitions:
Not to be used in residential
area!
No fire, open light and
smoking!
11
No covering
Warning:
Warning/caution
Do not use the appliance in
closed spaces!
Commands:
General command symbol
Environment protection:
Dispose waste professionally
so as not to harm the
environment.
Faulty and/or disposed electric
or electronic appliances must
be taken to appropriate
collection centres.
Package:
Protect against moisture
Interseroh-Recycling
Technical specifications:
Connection
Heating output
Tank capacity
Warning against dangerous
voltage
Warning against flammable
materials
Read the Operating
Instructions before using
the appliance
Packing cardboard material
may be delivered to
collecting centres for
recycling.
This side up
Weight
Turbine output
Fuel consumption
6