Fronius TransPocket 1500 RC HD Instructions De Service page 38

Preventive and
corrective
maintenance
(continued)
Safety inspection
Safety markings
Copyright
ud_fr_st_sv_00467 022002
When ordering spare parts, please state the exact designation and the
relevant part number, as given in the spare parts list. Please also quote the
serial number of your machine.
The owner/operator is obliged to have a safety inspection performed on the
machine at least once every 12 months.
Fronius also recommend the same (12-month) interval for regular calibration
of welding equipment.
A safety inspection, by a trained and certified electrician, is prescribed:
- after any alterations
- after any modifications or installations of additional components
- following repairs, care and maintenance
- at least every twelve months.
Observe the relevant national and international standards and directives in
connection with the safety inspection.
More detailed information on safety inspections and calibration is available
from your regional or national Fronius service centre, who will be pleased to
provide you with copies of the necessary documents, standards and
directives upon request.
If the machine fulfils the fundamental requirements of the Low-Voltage and
Electromagnetic Compatibility Directive, it will be CE-marked.
If the machine has been tested by the CSA, it will bear the relevant CSA
mark of conformity. The CSA mark of conformity on the unit applies both to
the USA and Canada.
Copyright to this instruction manual remains the property of Fronius Interna-
tional GmbH.
The text and illustrations are all technically correct at the time of going to
print. The right to effect modifications is reserved. The contents of the
instruction manual shall not provide the basis for any claims whatever on the
part of the purchaser. If you have any suggestions for improvement, or can
point out to us any mistakes which you may have found in the manual, we
should be most grateful for your comments.
X