Storage; Troubleshooting - TOOLCRAFT 1550315 Notice D'emploi

13. Storage

• Store the product and its accessories in a dark, dry and frost-free location when you are not using it. The product
should be stored at the temperature indicated in the "Technical data" section.
• We recommend that you store the product in its original packaging.

14. Troubleshooting

Fault
The motor does not turn on when
the switch is pressed.
The push buttons (6/7) are pressed.
The motor makes a noise, but the
load is not lifted.
The brakes do not hold and the
load drops.
32
Possible cause
The mains cable is not connected
to the mains.
The cables are damaged.
The switch is defective.
The capacitor is defective.
The stop/limit switch was not reset,
or the switch is faulty.
The thermostat switched the motor
off.
One of the thermostat wires is
broken.
The mains voltage is too low.
The capacitor is damaged.
The brake mechanism did not fully
open.
The gap between the drum and the
brake disk is too high.
The brake spring is broken.
The brake drum is not moving.
The brake disk is dirty.
Solution
Plug the mains cable into the
mains.
Check the cables and plug for signs
of damage, or reconnect the cables
and try again.
The switch needs to be replaced or
repaired.
The capacitor needs to be
replaced.
Check the
limit/stop switch and replace if
necessary.
Wait until the motor has cooled
down.
Replace the thermostat.
Use the correct mains voltage.
The capacitor needs to be
replaced.
Contact a technician to repair the
product.
Contact a technician to repair the
product.