Maintenance - TOOLCRAFT 1550315 Notice D'emploi

• Oil the drum shaft, gear mechanism and bearings every six months.
• Every 1000 cycles, check all wearing parts such as the rope, chain, hook, belts and brake linings.
• Before each use, check that the emergency off switch (9) and push buttons (6/7) are working properly.
• Check that brake system every 1000 cycles. If the motor (2) makes unusual sounds or fails to lift the load, the brake
system may need to be repaired.
- Replace damaged or worn parts and retain all repair documentation.
- If the appliance needs to be repaired, contact an authorized repair centre for assistance.
b) Maintenance
• Check the hoist for signs of wear and tear at least once a year.
• Check periodically to verify that the retaining screws, clamps and gear unit are securely in place.
• Check periodically to verify that the nuts for the rope clamp are secure and intact.
• Check periodically to verify that the motor switches (up/down buttons and safety switches) are functioning properly.
• Check periodically to verify that all moving parts (including the hook, drum axis, gear mechanism and shaft) are
well-lubricated / oiled.
The rope (12) should be checked every 30 cycles to ensure that it is in good condition (see
diagram). If individual strands are broken or damaged, the rope must be replaced with a
rope that conforms to the specifications in the "Technical data" section.
Check periodically to verify that the rope is in good condition. If there are signs of damage
or wear and tear (as shown in the diagram), the rope must be replaced at a specialist repair
centre.
31