Before using your bike, check the condition of parts that can wear, including the rims, brakes, tyres, steering and transmission of your bike. In the event of abnormal wear or

any deformation, have your bike checked by a Decathlon workshop.

HYDRAULIC DISC BRAKES:

Safety and adjustment of the brakes:

For your safety, check the front and rear brakes before each use of your bike. They must be in perfect condition. Check all brake mounting components regularly. Disc brakes

should be checked regularly. In the event of a brake fluid leak, action is required. Get in touch with a Decathlon workshop.

Setting up the brakes:

The break-in procedure involves gradually braking several times, at increasing speeds. It is important to alternate the front and rear brakes and observe the following steps:

1. Ride at 15 km/h and gradually brake to 5 km/h, 10 times in a row.

2. Ride at 20 km/h and gradually brake to 5 km/h, 10 times in a row.

3. Ride at 25 km/h and gradually brake to 5 km/h, 10 times in a row.

Between each stage, release and ride a few dozen metres to properly ventilate the disc and caliper.

WHEELS:

Regularly check the wheels. Refer to the wear indicators if the rims have them (on the outside or inside of the rim) and replace them if necessary. Make sure the wheels are

tight.

Tyre pressure :

MIN 3 - MAX 5,5 BAR

MIN 43- MAX 80 PSI

Regularly check the tyres and check the pressure. The pressure is shown on the side of the tyre and/or rim. If the pressure is indicated on both the rim and the tyre, inflate

the tyres with the maximum pressure indicated on the rim independently of the maximum pressure indicated on the tyre. The rims may have a different and lower maximum

pressure than the tyres. The bike will perform best with tyres inflated to between 3 and 5,5 bar. The risk of puncture is high if the tyres are underinflated. Battery life will also

be affected.

TRANSMISSION:

A chain that is not tight enough can come off and cause falls, while a chain that is too tight impedes the performance of the bike. Regularly check the chain tension. The bike

chain is automatically tensioned since the bike is equipped with a derailleur.

ELECTRICAL SYSTEM:

When using it for the first time, remember to plug in your battery to wake it up and recharge it. Make sure your electrical system is functioning properly. To use the electric

assistance, before setting off on a ride, make sure all the connectors on the bike are properly connected and your battery is charged. Turn on the bike by pressing the ON/

OFF button, then select the required assistance mode. Do not use or store the bike with the charging port cover open. Open the charging port only for charging or connecting

a range extender.

MIN 3 - MAX 5,5 BAR

MIN 43- MAX 80 PSI