Publicité
This parameter allows you to set the speed at which system-exclusive data (Momentum, Sound, Song and All-Data
Dumps) is sent from the Sirius. The factory setting should work with all common Sequencing programmes and
MIDI-interfaces. Apart from this setting it is also possible the speed up the TX of the data (position FAST) or to
slow it down (position SLOW). To find the best TX speed it is advisable to try out all three options. If the setting
FAST works with your MIDI-interface there is nothing against using it permanently - it will increase your work-
speed enormously.
Caution: This parameter should only be changed by you when you have already had experience in data-
Dumping different data types. More information on the different Data-Dump-types and how to transmit them you
will find in the section "Data-Dumping" in the WRITE-menu section of this manual.
Menu-page 13 (Poti-Snap):
This parameter is about the behaviour of the dial controls on the front panel of the Sirius. Just experiment with the
setting options of this parameter. These functions allow you to increase ease of operation of the Sirius and to
customise it to your special requirements. In the factory setting OFF, the controls on the front panel will behave as
follows:
As soon as you turn a dial the value corresponding to the control setting is called up. The resultant sound changes
(for example when changing the Cutoff-frequency) can in some situations be unwanted. We have therefore
provided the new Pot-Snap function to the Sirius. It is activated in its ON setting.
Now the Pots will behave as in the following example: Let's assume the Cutoff-frequency of a sound has the value
100. The Cutoff-control is however set to 20. Without Pot-Snap the cutoff frequency would immediately take on
the value 20 when you move the control. A clear jump would be audible. With the activated Pot-Snap you can
however move the control without hearing a jump. Only when you exceed the value 100 will the sound start to
change. In order for you to know which value is set for the currently selected sound and in which direction the dial
must be turned in order to find it is indicated in the display while turning the dial. For our example the display
would look as follows:
In this example the display shows you that you will have to turn the control to the right and that you will only hear
a change in sound once you have passed a Cutoff-value of 100.
Menu-page 14 (Poti Info):
This parameter lets you decide if you want to have the parameter and the relevant value displayed or not when you
turn a dial. The factory setting for this function is switched to ON. The OFF setting disables this function.
Menu-page 15 (Track Mute):
When you have come this far in the manual you will surely have noticed that the two lower octaves of
the Sirius-keyboad allow you to mute and un-mute tracks as well as transpose them. The parameter on
this page allows you to turn this function off. The factory setting makes this function active, and so the
parameter is set to ON.
Edit System/Midi
<13> PotSnap:OFF
A22:SawBass 130
-> Cutoff: 100
Edit System/Midi
<14> PotInfo: ON
Edit System/Midi
<15> TrkMute: ON
109
The System-Menu
Publicité
