Publicité
Menu-page 5 (MIDI-Synchronisation):
Page 5 of the System-menu contains a parameter which can also be set on the front panel of the Sirius. Here you
have 3 settings to choose from:
In the first setting 'INT' (factory setting), the Sirius creates its own sequencer tempo with its own clock.
In the position 'EXT' the Sirius can be synchronised to an external MIDI-clock. The setting 'AUD' makes the Sirius
ready to be synchronised with an audio-signal (Beat-Reconition-System). To activate the Synchronisation
parameter you will not have to open the System-menu because there is a key for these 3 functions on the front
panel of the Sirius. This key is marked SYNC.EXTERN/AUDIO.SYNC. If this key is not lit it means you are in
the 'INT' mode. If the key is lit, the Sirius is in the 'EXT' mode. If the key is blinking the Beat-Recoginition-System
is activated. This is the 'AUD' mode.
Menu-page 6-11 (Send- and Receive-Functions):
The Parameters on the following 6 menu pages are Send and Receive filters for certain MIDI-data types. There you
can determine if a particular data type is to leave the Sirius through the MIDI-Out socket or to reach it via the
MIDI-In socket. The abbreviations RX and TX stand for Receive and Transmit respectively.
Menu-page 6 (Receive Program-Change):
Edit System/Midi
<5> MidiSync:INT
Edit System/Midi
<5> MidiSync:EXT
Edit System/Midi
<5> MidiSync:AUD
Edit System/Midi
<6> RxPrgChg: ON
107
The System-Menu
Publicité
