Publicité
6.8.4 - Clearing the entire receiver memory
Exit any menu, press and hold the
1. Press and hold the
(DOWN-RADIO) button until the KEY LED lights up (approx. three seconds);
press and hold the
(DOWN-RADIO) button until the KEY LED goes out; release the button.
2. After releasing the button, the KEY LED starts flashing slowly; count the flashes.
3. At the third flash, briefly press the
4. A long flashing of the KEY LED indicates that all remote controls have been deleted.
5. The control unit exits the RADIO MENU menu after seven seconds of inactivity or by briefly pressing
6.9 - Reset to factory settings
Per riportare tutti i parametri ai loro valori predefiniti o per modificare il tipo di apparecchiatura su cui è installata la centrale, procedere come
segue:
1. Press and hold the
(MENU) button; the display shows
Release the button when
ADV is highlighted
2. Scroll through the menu items using the
SETUP
3. Press and hold the
(MENU) button, release the button when the display starts to flash; the number displayed
indicates the type of motor in use.
4. Use the
(UP) and
(DOWN-RADIO) buttons to select the motor type; press and hold the
The display shows a countdown from 50 to 0; release the button when the word DONE.
5. The control unit exits MENU after seven seconds of inactivity or by briefly pressing
6.10 - Customising the system - BASIC MENU AND ADVANCED MENU
The configuration menus for the equipment's operating functions are divided into BASIC and ADV (ADVANCED). The following tables show the
description of each parameter with their respective minimum, maximum and default value
1. Press and hold the
(MENU) button; the display shows BASIC and ADV in sequence
Release the button when BASIC is displayed;
2. Scroll through the menu items using the
reached.
3. Press and hold the
(MENU) button until the display flashes; release the
4. To change the value, press the
the
(MENU) button until the display stops flashing;
5. The control unit exits MENU after seven seconds of inactivity or by briefly pressing
NOTE: to display the value of any parameter, simply enter the relevant menu (BASIC or ADV) using steps 1 and 2 of
the procedure just described. Once the desired parameter is found, the display alternately shows the parameter name
and value. To exit the menu, briefly press the
(DOWN-RADIO) button until the display alternately shows RADIO MENU.
(DOWN-RADIO) button.
and
BASIC
.
(UP) and
(DOWN-RADIO) buttons until you reach
(UP) and
(DOWN-RADIO) button until the desired parameter is
(UP) and
DOWN-RADIO) keys; to confirm the new value, press and hold
(MENU) button.
.
ADV in sequence
MOTOR
(MENU) button.
(MENU)
(MENU) button
(MENU)
►
MENU RADIO
►
►
+3s
(MENU)
base
►
►
►
►
done
base
►
►
►
►
EN
►
ADV
ADV
17
Publicité
