Publicité
7.2.2 Installing the Alkaline Battery
1. Insert the AA alkaline batteries in the battery compartment, aligning the + on
each battery with the + shown inside the battery compartment.
2. Close the battery door and push it upwards.
3. Tighten the screw that secures the battery door to the pulse monitor.
Caution: Check the batteries periodically for corrosion.
Replace batteries if corrosion is present, otherwise damage
to the monitor may occur.
Caution: Do not run the pulse monitor using alkaline
batteries of different types or capacities at the same time.
7.2.3 Installing the Lithium Ion Battery
1. Insert the lithium ion battery in the battery compartment, following shown as
follows:
2. Close the battery door and push it upwards.
3. Tighten the screw that secures the battery door to the pulse monitor.
Fig 7-3 Install the battery
93
www.spengler.fr
Press the
battery in
Publicité
