Publicité
2. Select the year, month and day on the right of Date , and set them to the
current date.
3. Select the hour and minute on the right of Time and set them to the current
time.
3.6 Selecting the Work Mode
The monitor is designed to operate in the continuous monitoring and spot-
checking mode. Its work mode is shown in the technical alarm area. You can set
the monitor's work mode as following steps:
1. Select System
input the password and select OK to enter the maintenance window shown
as follows:
2. Select Work Mode , you can set the monitor's wok mode to Continuous or
Spot-Check .
3.6.1 Continuous Monitoring Mode
The continuous monitoring mode is intended for long-term monitoring. This
mode is normally selected when the patient is in hospital or under transport. At
the time, the patient ID defaulted by the system is 0. When the memory reaches
the above limit, the data stored primarily will be cleared.
Maintenance , a password entering window will pop up,
Fig 3-3 Maintenance window
75
www.spengler.fr
Publicité
