Publicité
3.2 Getting Started
1. Before you start to make measurements, carry out the following checks on the
monitor including all connected modules.
- Check for any mechanical damage;
- Check for any incorrect connection of all the external cables and accessories.
2. Put batteries into the battery compartment. Make sure that the battery has
sufficient power for monitoring. When you use a lithium battery for the first
time, you must charge it, following the instructions given in Battery chapter.
Warning:
• Warning: If the monitor is mechanically damaged, or if it
is not working properly, do not use it for any monitoring
procedure on a patient. Contact your service personnel.
• To avoid explosion hazard, do not use the monitor in the
presence of flammable anesthetics, vapors or liquids.
3.3 Starting the monitor
Press the button
and then goes out. The system gives a beep and enter the main screen. For you
to use the monitor more conveniently, after starting the monitor you can make
the following setting as shown in section 3.4 first.
3.4 General Setup
Press the Left button to enter Menu , then select General Setup to enter the
general setup menu shown as follows. You can set the following parameters'
values.
to turn on the monitor. The alarm indicating lamp flashes,
Fig 3-1 General setup window
73
www.spengler.fr
Publicité
