Publicité
Check that the purchased product is the right size for the
installation location; Check for accessories inside the pack-
aging (placed there for ease of transport, such as bags con-
taining screws, the warranty certificate, etc.). Remove and
keep them safe; Also check that there is a power socket
near the installation area
● Preparing the cabinet for installation:
• The product cannot be installed above cooling appli-
ances, dishwashers, heaters, ovens, washing machines and
dryers; Create the cut-outs in the cabinet before inserting
the hob and carefully remove shavings or sawdust.
The minimum distance between the hob and the wall must
be at least 50mm from the front, at least 50mm from the
sides and at least 500mm from the upper wall units.
NB: when designing the space, the kitchen manufacturer's
instructions must be followed.
• to optimise the recirculating installation, it is recommen-
ded to create a slot in the plinth, in which to insert a com-
mercial grille.
• Important: use a single component adhesive sealant (S)
that can withstand high temperatures up to 250°; before in-
stallation, the surfaces that need to be glued must be thor-
oughly cleaned, removing all substances that may com-
promise adhesion (e.g. release agents, preservatives,
grease, oils, powders, old adhesive residue, etc.); the adhes-
ive must be evenly spread along the entire perimeter of the
frame; after gluing, leave the adhesive to dry for about 24
hours.
● Please note! Failure to install screws and fasteners in ac-
cordance with these instructions may result in electrical
hazards.
● Note: for correct installation of the product, it is recom-
mended to tape the pipes using an adhesive with the fol-
lowing characteristics: soft elastic PVC film, with acrylic-
based adhesive; complies with DIN EN 60454 regulations;
44
Publicité
