Publicité
● If the product is not equipped with a power cable, use
2
one with a minimum conductor section of 2.5 mm
for
power up to 5500 Watt; while for higher powers it must be
2
4 mm
).
● Please note! The interconnection cable must be replaced
by the authorised customer service representative or by a
person with similar qualifications.
● Please note! Before reconnecting the circuit to the mains
power supply and making sure that it is working correctly,
always check that the power cable is correctly installed.
The product can also be used in conjunc-
WINDOWS KIT:
tion with a Window sensor KIT (not supplied by the manu-
facturer). If the Window sensor KIT is installed (only if used
in DUCT-OUT mode), air extraction will halt every time the
window in the room, on which the KIT is applied, is closed.
The KIT must be electrically connected to the device by
qualified and specialised technical personnel. The KIT
must be certified separately in accordance with the safety
standards for the component and its use with the device.
Installation must be carried out in accordance with current
regulations for domestic systems.
PLEASE NOTE: the wiring of the KIT to be connected to the
product must be part of a certified safety extra-low
voltage (SELV) circuit. The manufacturer of this device dis-
claims all liability for any inconvenience, damage or fires
caused by defects and/or problems associated with the
malfunction and/or incorrect installation of the KIT.
INSTALLATION SAFETY
● The electrical and mechanical installation must be per-
formed by qualified personnel.
● Before starting the installation: After unpacking the
product, check that it has not been damaged during trans-
port and in the case of problems, contact your dealer or
Customer Service, before proceeding with the installation;
43
Publicité
