Publicité
Cleaning and maintenance
-Lubricate the moving parts periodically to prevent premature wear.
-Inspect and tighten all parts before using the machine. Replace any defective parts
immediately, and do not use the equipment again until it is in perfect working condition.
-The machine can be cleaned using a slightly damp cloth and mild non-abrasive deter-
gent. Do not use solvents.
-Do not try to repair the machine by yourself. Should you have any difficulty with the
assembly or operation of the exercise bike, or if you think that any part is miss-ing, contact
the official Prixton Technical Support Service.
Note: The cleaning and maintenance frequency depends on the use frequency and
intensity.
Troubleshooting
Problem
The base is unstable
Cause
The ground is not flat or there is an object under the stabiliser. The rear stabiliser end caps
have not levelled out when adjusted.
Solution
Remove the object. Tighten the rear stabiliser end caps.
Problem
The handlebar is not stable
Cause
The screws are loose.
Solution
Tighten the screws.
Problem
Loud noise from moving parts
Cause
The parts are not tightened properly.
Solution
Tighten them.
Trouble shooting guide
1.Verify that all the bolts and nuts are locked properly and the turning parts should be
turned freely without damaged parts.
2.Clean the equipment with soap and slightly damp cloth only. Please do not use any
solvent to clean the equipment.
Problem
Base is unstable.
Cause
1.Floor is not flat or there is small object under the front or rear stabilizer.
2.The rear stabilizer end caps have not been leveled when adjusting.
Solution
1.Remove the object.
2.Adjust the rear stabilizer end caps.
Problem
Handlebar is shaking.
Cause
The Bolts are loose.
Solution
Tighten the Bolts.
Publicité
