Publicité
11. Install the 2 screws, the 6 washers and the 2 nuts on
the left side of the handle.
12. Install the 2 screws, the 6 washers and the 2 nuts on
the right side of the handle.
13. Connect the cables to the control panel and the blast
motor.
To replace the front rubber seals
WARNING:
are necessary for this procedure. 1 person
replaces the front seals, and 1 person holds
the product in position.
1. Operate the product rearward up a ramp.
2. Do the steps that follow to tilt the product rearward:
a) 1 person pushes down on the handle of the
product to tilt the product rearward (A).
B
b) The second person puts a piece of wood below
the front of the product (B).
c) 1 person continues to hold the product in position
by the handle.
2107 - 003 - 13.12.2023
A minimum of 2 persons
A
3. The second person continues with the process to
replace the front rubber seals:
a) Loosen the 6 nuts and then loosen the 3 bolts.
b) Remove the front rubber seals.
c) Install the new front rubber seals (C) with the
steel strips (D) between the front rubber seals.
The angle strip (E) is part of the body and can
not come off.
D
E
D
D
C
C
C
25
Publicité
