Publicité
3. Remove 8 screws, the 16 washers, the 8 nuts and
the hopper.
4. Remove the 2 screws, the 4 washers, the 2 cage
clamps and the control cage.
5. Put an applicable tool in the blast wheel blades to
prevent rotation. Remove the bolt and discard it.
6. Remove the impeller.
2107 - 003 - 13.12.2023
To install the impeller
1. Clean the threads of screw hole for the bolt for the
impeller with pressurized air.
2. Install the impeller.
3. Block the blast wheel blades with an applicable tool
and install the bolt for the impeller.
CAUTION:
CAUTION:
install the bolt. It can cause damage to
the threads.
Always use a new bolt.
Do not use force to
21
Publicité
