Publicité
4. Install the 2 screws, the 4 washers, the 2 cage
clamps and the control cage.
5. Install the 8 screws, the 16 washers, the 8 nuts and
the hopper.
To remove the blast wheel blades
1. Remove the impeller. Refer to
impeller on page 20 .
2. Disconnect the cable to the blast motor.
22
To remove the
3. Disconnect the cables to the control panel.
4. Remove the 2 screws, the 6 washers and the 2 nuts
on the left side of the handle.
5. Remove the 2 screws, the 6 washers and the 2 nuts
on the right side of the handle.
6. Remove the handle and the control panel.
2107 - 003 - 13.12.2023
Publicité
