Publicité
5. Examine the position of the control cage window.
6. Turn the control cage clockwise, if the hotspot is too
much on the right side.
18
7. Turn the control cage counterclockwise, if the
hotspot is too much on the left side.
8. Make sure that the hotspot is equally applied on the
surface for correct adjustment.
9. Tighten the cage clamps when the control cage is in
correct position.
To stop the product
1. Close the valve for the abrasive material. Refer to
operate the valve for the abrasive material on page
12 .
To
2107 - 003 - 13.12.2023
Publicité
