Publicité
•
Turn the speed control clockwise to increase the
speed.
•
Turn the speed control counterclockwise to decrease
the speed.
To start the product
1. Connect the product to a power supply. Refer to
connect the product to a power source on page 15 .
2. Attach the dust collector hose to the product. Refer
To connect a dust collector on page 15 .
to
3. Start the dust collector. Refer to the operator's
manual of the dust collector.
4. Put the cord of the operator presence control around
your left wrist.
5. Turn the emergency stop button clockwise to
disengage the emergency stop button.
6. Set the ON/OFF switch to the ON position (A).
B
C
7. Start the drive motors (B) and the fan unit (C).
8. Do a check of the direction of rotation of the fan unit.
To do a check of the direction of rotation of
Refer to
the fan unit on page 15 .
9. Start the the blast motor (D).
To operate the product
WARNING:
during operation. Abrasive material comes
16
D
A
Do not lift or tilt the product
out of the product at high speed and can
cause injury.
1. Make sure that the work area is safe. Refer to
area safety on page 8 .
2. Fill the separator with abrasive material. Refer to
fill the product with abrasive material on page 14 .
3. Start the product. Refer to
page 16 .
4. Set the speed control dial to the lowest the speed.
5. Push the 2 joysticks forward to operate the product
forward.
To
6. Press and hold the STOP button for the left drive
motor to turn the product to the left. Press and hold
the STOP button for the right drive motor to turn the
product to the right.
7. Pull the control lever for the abrasive material to
open the valve. Refer to
the abrasive material on page 12 .
8. After 2 m/7 ft., push the control lever for the abrasive
material to close the valve.
9. Stop the product.
10. Do a check of the blast pattern. Adjust the blast
pattern if it is necessary. Refer to
pattern on page 17 .
11. Select the correct speed. Refer to
product on page 16 .
Work
To start the product on
To operate the valve for
To adjust the blast
To operate the
2107 - 003 - 13.12.2023
To
Publicité
