2. Push the stop button for the blast motor (A), the fan
unit (B) and the drive motor (C).
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
WARNING:
equipment when you do servicing and
maintenance. Refer to
equipment on page 7 .
WARNING:
maintenance, stop the motors and
disconnect the power plug from the power
source. Make sure that all drives stop.
General product maintenance
Empty the dust collector.
Do a check of the of the sepa-
rator and the separator tray.
Make sure that the power plug
and extension cable are in
good condition and not dam-
aged.
Do a check of the electrical
components, the cables and
the connections for wear and
damages.
2107 - 003 - 13.12.2023
A
B
C
Maintenance
Before you do
Use personal protective
Personal protective
Before you do the
Each 3 h
*
X
3. Turn the ON/OFF switch to the OFF position.
4. Disconnect the power plug from the power supply.
5. Stop the dust collector. Refer to the operator's
manual of the dust collector.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
For more detailed information, refer to
www.husqvarnaconstruction.com.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
12 h after
Daily
servicing
*
*
Each 3
Yearly
months
19