Publicité
12. Move the product (A) in parallel tracks. The dust
collector (B) must be connected to the product (A) by
the dust collector hose (C).
C
A
B
13. Push the left joystick backward to turn the product
around 360° to the left.
14. Push the right joystick backward to turn the product
around 360° to the right.
Blast pattern
The blast pattern (A) is the surface that has received
treatment.
A
For a good result the hotspot must be in the center of
the blast pattern. If the hotspot is too far to the left or
to the right, turn the control cage. Refer to
blast pattern on page 17 .
These are the conditions that have effect on the blast
pattern:
•
The direction of rotation of the blast blades is
correct.
•
Increased wear on the blast blades, impeller and
control cage.
•
The dimension of the abrasive material. It is
necessary to adjust the blast pattern when you use
abrasive material with different dimension.
2107 - 003 - 13.12.2023
•
The position of the lateral window in the control
cage.
•
Different types and hardness of the surface.
To adjust the blast pattern
1. Open the separator door and look if there is abrasive
material in the hopper. If there is abrasive material
in the hopper, empty it. Refer to
material from the hopper on page 20 .
2. Disconnect the power plug.
3. Remove the 8 screws, the 16 washers, the 8 nuts
and the hopper.
4. Loosen the cage clamps.
To adjust the
WARNING:
Do not adjust, loosen or
touch the cage clamps or the blast wheel
blades when the product is on. Disconnect
the power supply when you adjust the blast
pattern.
WARNING:
Use personal protective
equipment when you adjust the blast
Personal protective
pattern. Refer to
equipment on page 7 .
To remove abrasive
17
Publicité
