Publicité
4. Put the side seal holder (C) around the side seal box
to make sure that the side seal stays in the correct
position.
5. Operate the product down the ramp.
WARNING:
operate the product down the ramp.
There is a risk of pinching.
6. Remove the side seal holder (D).
7. Do the procedure on the other side of the product.
8. Make sure that you can see the 2 axles of the side
seal spring plate on top of the side seal box.
Abrasive material
Speak to your Husqvarna dealer for the selection of
correct abrasive material for your surface operation.
Approved abrasive material on page 33 .
Refer to
14
C
Be careful when you
D
Separator
The separator (A) holds the abrasive material and
supplies the blast wheel blades with abrasive material
through the hopper (B).
B
The separator tray keeps contamination away from the
abrasive material and the blast wheel blades.
To fill the product with abrasive
material
WARNING:
protective equipment when you fill the
product with abrasive material. Refer to
Personal protective equipment on page 7 .
1. Close the valve for the abrasive material, refer to
operate the valve for the abrasive material on page
12 .
A
Always use personal
2107 - 003 - 13.12.2023
To
Publicité
