Migatronic PI 320 DC Manuel D'instruction page 26

Reset to factory settings
of a single program
Select the program in question, then press and
keep pressed the
turning the encoder. The display will show the current
program number by flashing the segments to confirm
the reset. Then you can release the key pad and the
current program will be reset to factory settings (see
values above).
The following diagram display all parameters and options of menu.
Exit from the USER menu
Open/Close the gas valve in order to purge
the torch, check the gas bottle and pressure
reducer. Press "A to Open/Close the gas. Exiting the
USER menu will close the gas anyway.
Submenu for wire feeder
Exit from submenu
Active control of CWF
0 = no CWF (default)
1 = at least one CWF
-key pad for 5 secs. without
USER MENU
This menu is intended to permit advanced
settings and controls of machine.
To access the user menu, press the knob
seconds when the machine is not welding, MMA or
TIG mode. Rotate the encoder to point the desired
option and activate the selection by pressing "A".
To change the values of parameters press the knob
MMA and rotate the encoder. Press "A" to save the
data. Exit from menu by pressing "- - -" with the "A"
knob.
Submenu containing different options:
Programs LOCK.
Protection of programs P3 to P10
for all procediment against unintentional
change of:
• welding currents, slopes, timing
• Trigger selection 2T/4T
• Current reference EXT/Internal
• Pulsations
It is still possible to select different
programs and welding procediment.
Programs P1 and P2 are unlocked,
permitting full control of relative
parameters.
When pressing locked key pads or rotating
the encoder for locked parameters, the
display will flash "PG.L." to remember the
active protection.
0 = unlocked (default setting)
1 = locked
and Encoder are disabled.
When pressing locked key pads or rotating
the encoder, the display will flash "PA.L." to
remember the active protection.
0 = unlocked (default setting)
1 = locked.
26
Exit from the submenu (go back to
main menu)
Panel LOCK.
Complete lock of box. All keypads
for 3