SKYLOTEC BEAMSTRAP Instructions D'utilisation page 8

GB Instruction for use
1.) Standards
1...1) Usage okay
1...2) Proceed with caution during usage
1...3) Danger to life
1...4) Not useable for this / Not available in this version
2.) General information
Before using the product read and understand these instructions...
Slings used as an anchor or as a lanyard to arrest falls, must not be
used without an energy absorber, for example a shock absorber as
per EN 355... The maximum permissible fall arrest force can be
found in the lanyard instructions... Only to be used with personal
fall-protection equipment; not with lifting equipment... Service life
depends on frequency of use and environmental conditions... For
improved monitoring, slings should be marked with the date of the
next inspection... (Do NOT label the webbing!)
ATTENTION: In wet/icy weather, if used over edges (2...6) and if
used with cow hitch knot (2.8) the failure load is significantly
reduced... Slack rope should be prevented...
2...1) I-shaped loop
2...2) O-shaped loop
2...3) Loop with twisted eye
2...4) Loop with stitched-in connection elements
2...5) product label
1... Relevant standards
2... Article number
3... Serial number
4... Material
5... Manufacturer + address
6... Product name (max... test load)
7... Length
8... Follow the instructions
9... Year and month of manufacture
10... QR code
11... CE marking of the supervisory body
2...6) If the risk assessment performed prior to beginning of the work
reveals that load above an edge is possible in case of fall,
appropriate precautionary measures must be taken...
2...7) Pay attention to loose strap ends / do not use for tying / always
close carabiners properly
2...8) If used with cow hitch knots, make sure that the loop strap is
correctly positioned
2...9) Do not knot fastener
8