SKYLOTEC BEAMSTRAP Instructions D'utilisation page 66

devices, locks); complete function must be assured. If unsure the
component is in a safe condition, immediately remove the
component in question.
3.2.) The equipment must be immediately removed from service
after a fall and checked by an expert. Use is subject to the written
consent of an approved person. If the equipment is no longer
suitable
for use, it must be disposed of.
4.) Safety requirements
The instructions on protecting the user and the equipment must be
strictly complied with! The product label must be completely legible!
If this is not the case, the product is no longer suitable for use! In
order to avoid a suspension trauma in case of a fall, there must be
an rescue plan available that is designed to reduce the amount of
time suspended while wearing a harness, and consequently to
prevent a circulatory collapse. SKYLOTEC suspension relief straps
can be used to provide protection against this. It is an important
requirement for the user to check all attachment and/or adjustment
parts regularly during use.
4.1) Application temperature -35 to +40 °C
4.2) Store dry and protected from light and transport correctly
4.3) Avoid slack rope
4.4) Avoid contact with corrosive substances
4.5) Consider danger of suspension trauma
4.6) Avoid edge loading and watch out for abrasive surfaces.
4.7) Consider danger from electrical equipment
4.8) Consider danger by moving machine parts
4.9) Do not put on personal protective equipment in the location
where there is a risk of falling.
4.10) Avoid heat and flames,
5.) Inspection and service life
A regular examination according to local regulations is required. In
Europe, for example, an annual inspection by an expert is
necessary. The replacement state depends on the product, its
frequency of use and the external application conditions. All PPE
unavoidably loses durability over the course of its service life. This
is accelerated by UV rays, heat, chemicals, aggressive
atmospheres, dirt.
6.) Maintenance and storage
The manufacturer's liability for defective products does not include
damage to property or personal injuries, which can occur even for
proper functioning and correct application of personal fall protection
equipment. The Manufacturer's liability will be rendered null and
void, if the equipment is modified or this manual and the accident
prevention regulations are disregarded. The equipment should be
available to its user individually. It is imperative to carry out a visual
and functional check of all fall protection components (other than
10